Una consola hecha de un redondo está cargada por un esfuerzo axil excéntrico. Determine the maximum vertical deflection of the console using the geometrically linear and second-order analysis.
Un voladizo está cargado por una fuerza transversal y axil en el extremo derecho y está completamente fijo en el extremo izquierdo. The problem is described by the following set of parameters. The problem is solved by using the geometrically linear analysis, second-order analysis, and large deformation analysis.
Una estructura hecha de un perfil en I está completamente fijada en el extremo izquierdo y empotrada en el apoyo deslizante en el extremo derecho. The structure consists of two segments. The self-weight is neglected in this example. Determine the maximum deflection of the structure, the bending moment on the fixed end, the rotation of segment 2, and the reaction force at point B by means of the geometrically linear analysis and the second-order analysis. The verification example is based on the example introduced by Gensichen and Lumpe.
Un voladizo de pared delgada de un perfil QRO está completamente fijado en el extremo izquierdo y el alabeo está habilitado. The cantilever is subjected to torque. Small deformations are considered, and the self-weight is neglected. Determine the maximum rotation, primary moment, secondary moment, and warping moment. The verification example is based on the example introduced by Gensichen and Lumpe.
Una viga está completamente fija (el alabeo está restringido) en el extremo izquierdo y está apoyada en un apoyo en horquilla (el alabeo está habilitado) en el extremo derecho. The beam is subjected to a torque, longitudinal force, and transverse force. Determine the behavior of the primary torsional moment, secondary torsional moment, and warping moment. The verification example is based on the example introduced by Gensichen and Lumpe.
Una viga articulada en ambos extremos está cargada con una fuerza concentrada en el medio. Neglecting its self-weight and shear stiffness, determine the beam's maximum deflection, normal force, and moment at the mid-span, assuming the second- and third-order analysis.
Un voladizo de perfil en I está apoyado en el extremo izquierdo y cargado por el par. The aim of this example is to compare the fixed support with the fork support and to investigate the behavior of some representative quantities. Comparison is also made to the solution by means of plates. Small deformations are considered, and the self-weight is neglected. Determine the rotation in the midpoint of the cantilever, and in case of the member entity with warping, determine the values of the primary torsional moment, the secondary torsional moment, and the warping moment both on the left end (point A) and the right end (point B).
Una viga de acero con una sección cuadrada está cargada con un esfuerzo axil y una carga distribuida. The image shows the calculation of the maximum bending deflection and critical load factor according to the second-order analysis.